Allied Telesis AT-S63 - Manual (Page 55)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 55
The System Configuration menu is shown in Figure 5.
Figure 5. System Configuration Menu
3. Adjust the following parameters as necessary.
Note
A change to any parameter in this menu, including the IP address,
subnet mask, and gateway address, is activated immediately on the
switch.
1 - BOOTP/DHCP
This selection activates and deactivates the BOOTP and DHCP client
software on the switch. For information on this selection, refer to
“Activating the BOOTP or DHCP Client Software” on page 57.
2 - IP Address
This parameter specifies the IP address of the switch. You must
specify an IP address if you want the switch to function as the Master
switch of an enhanced stack. The IP address must be entered in the
format: xxx.xxx.xxx.xxx. The default value is 0.0.0.0.
3 - Subnet Mask
This parameter specifies the subnet mask for the switch. You must
specify a subnet mask if you assigned an IP address to the switch. The
subnet mask must be entered in the format: xxx.xxx.xxx.xxx. The
default value is 0.0.0.0.
4 - Default Gateway
This parameter specifies the default router’s IP address. This address
is required if you intend to remotely manage the switch from a
management station that is separated from the switch by a router. The
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
System Configuration
1 - BOOTP/DHCP ............. Disabled
2 - IP Address ............. 0.0.0.0
3 - Subnet Mask ............ 0.0.0.0
4 - Default Gateway ........ 0.0.0.0
5 - System Name ............
6 - Location ...............
7 - Administrator ..........
8 - Configure System Time
A - ARP Cache Timeout
R - Return to Previous Menu
Enter your selection?