Allied Telesis AT-S63 - Manual (Page 488)

Chapter 22: SNMPv3
488 Section IV: SNMPv3
The range is 0 to 255 retries. The default is 3 retries.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Target Address Tag List
To modify the Target Address Tag List parameter in an SNMPv3 Target
Address Table entry, perform the following procedure.
1. Follow steps 1 through 5 in the procedure described in “Creating an
SNMPv3 User Table Entry” on page 430. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 148 on page
431.
2. From the Configure SNMPv3 Table menu, type 7 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Address Table menu is shown in
Figure 159 on page 480.
3. From the Configure SNMPv3 Target Address Table menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Address Table menu is shown in Figure
160 on page 484.
4. To modify the Target Address Tag List, type 5 to select Set Target
Address TagList.
The following prompt is displayed:
Enter Target Address Name:
5. Enter a previously configured Target Address Name.
This is the name of the SNMP manager, or host, that manages the
SNMP activity on your switch. You can enter a name of up to 32
alphanumeric characters.
The following prompt is displayed:
Enter Tag List:
Enter a Tag List of up to 256 alphanumeric characters. Use a space to
separate entries. This list consists of a tag or list of tags you configured
in a Configure SNMPv3 Notify Table entry with the Notify Tag
parameter. See “Creating an SNMPv3 Notify Table Entry” on
page 472.