Allied Telesis AT-S63 - Manual (Page 848)

Chapter 37: Management Access Control List
848 Section VIII: Management Security
Adding an ACE
To add a new ACE to the management ACL, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 54.
2. From the System Administration menu, type 7 to select Management
ACL.
The Management ACL Configuration menu is shown in Figure 290 on
page 846.
3. From the Management ACL Configuration menu, type 2 to select Add
Management ACL Entry.
The following prompt is displayed:
Enter the IP address:
4. Enter the IP address of a specific management station (for example,
149.11.11.11) or a subnet (for example, 149.11.11.0). You must enter
an IP address.
The following prompt is displayed:
Enter the Mask:
5. Enter a mask that indicates the parts of the IP address the switch
should filter on. A binary “1” indicates the switch should filter on the
corresponding bit of the address, while a “0” indicates that it should
not. If you are filtering on a specific IP address, use the mask
255.255.255.255. If you are filtering on a subnet, enter the appropriate
mask. For example, to allow all management stations in the subnet
149.11.11.0 to manage the switch, you would enter the mask
255.255.255.0.
The following prompt is displayed:
Enter the Protocol [TCP]:
6. Enter TCP.
The following prompt is displayed:
Enter the Interface [TELNET/WEB/ALL]: