Allied Telesis AT-S63 - Manual (Page 172)

Chapter 8: Static and LACP Port Trunks
172 Section I: Basic Features
The Modify LACP (IEEE 8023ad) Aggregator menu is shown in Figure
48.
Figure 48. Modify LACP (IEEE 8023ad) Aggregator Menu
5. Type 1 to select Aggregator or 2 for Adminkey and, when prompted,
enter the name or adminkey of the aggregator you want to modify. You
can specify the aggregator by its name or adminkey number. The
name is case-sensitive. (To display the names and adminkeys of the
aggregators on a switch, refer to “Displaying LACP Port and
Aggregator Status” on page 175)
After you enter the aggregator’s name or adminkey, the specifications
of the aggregator are displayed in the menu.
6. Configure the following parameters as necessary:
1 - Aggregator
Specifies a name for the aggregator. The name can be up to twenty
alphanumeric characters. Spaces are allowed, but special characters,
such as asterisks and exclamation points, are not. Each aggregator
must have a unique name.
2 - Adminkey
Specifies a unique adminkey value for the aggregator. The value is
entered in hexadecimal. The range is 1 to FFFF. For background
information, refer to “Adminkey Parameter” on page 153.
3 - Distribution Mode
Sets the load distribution method. Possible settings are:
ˆ SRC MAC - Source MAC address
ˆ DST MAC - Destination MAC address
ˆ SRC/DST MAC - Source address /destination MAC address
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Modify LACP (IEEE 802.3ad) Aggregator
1 - Aggregator ..................
2 - Adminkey .................... 0x0000
3 - Distribution Mode ........... SRC/DST MAC
4 - Port Range ..................
M - Modify Aggregator
R - Return to Previous Menu
Enter your selection?