Allied Telesis AT-S63 - Manual (Page 621)

AT-S63 Management Software Menus Interface User’s Guide
Section VI: VLANs 621
2 - VLAN ID (VID)
This is the VLAN’s VID value. You cannot change this value.
3 - VLAN Type
VLAN type should be Port Based for a port-based or tagged VLAN.
You cannot change this value.
4 - Tagged Ports
Use this selection to add or remove tagged ports from the VLAN. You
can specify the ports individually (e.g., 2,3,5), as a range (e.g., 7-9), or
both (e.g., 2,5,7-9).
When you add or remove tagged ports, observe the following
guidelines:
ˆ The new list of tagged ports will replace the existing tagged ports.
ˆ If the VLAN contains tagged ports and you want to remove them
all, enter 0 (zero) for this value.
5 - Untagged Ports
Use this selection to add or remove untagged ports from the VLAN.
You can specify the ports individually (e.g., 2,3,5), as a range (e.g., 7-
9), or both (e.g., 2,5,7-9).
When you add or remove untagged ports, observe the following
guidelines:
ˆ The new list of untagged ports will replace the existing untagged
ports.
ˆ If you want to remove all untagged ports from the VLAN, enter 0
(zero) for this value.
ˆ You cannot change the name of the Default_VLAN, nor can you
directly remove untagged ports from the Default_VLAN. Instead,
you must assign the port as an untagged port to another VLAN.
An untagged port removed from a VLAN is automatically returned to
the Default_VLAN as an untagged port.
Note
Selection 6, Protected Ports, should be left in the “No” default setting
when modifying a port-based or tagged VLAN. This option is
explained in Chapter 28, “Protected Ports VLANs” on page 671.
7. After making the desired changes, type M to select Modify VLAN.
The following message is displayed:
SUCCESS
Please make sure to manually update any static
multicast MAC address(es) entries for this VLAN.
Press any key to continue...