Allied Telesis AT-S63 - Manual (Page 675)

AT-S63 Management Software Menus Interface User’s Guide
Section VI: VLANs 675
Creating a Protected Ports VLAN
To create a new protected ports VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
2. From the VLAN Configuration menu, type 4 to select Configure
VLANs.
Note
If the menu does not include selection 4, Configure VLANs, the
switch is running a multiple VLAN mode. To change the switch’s
VLAN mode, refer to “Selecting a VLAN Mode” on page 668.
3. From the Configure VLANs menu, type 1 to select Create VLAN.
The Create VLAN menu is shown in Figure 232.
Figure 232. Create VLAN Menu
4. Type 1 to select VLAN Name.
The following prompt is displayed:
Enter new value ->
5. Type a name for the new protected ports VLAN.
The name can be from one to fifteen alphanumeric characters in
length. The name should reflect the function of the nodes that will be a
part of the protected ports VLAN (for example, InternetGroups). The
name cannot contain spaces or special characters, such as asterisks
(*) or exclamation points (!).
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Create VLAN
1 - VLAN Name ............
2 - VLAN ID (VID) ........ 2
3 - Tagged Ports .........
4 - Untagged Ports .......
5 - Protected Ports ...... No
C - Create VLAN
R - Return to Previous Menu
Enter your selection?