Allied Telesis AT-S63 - Manual (Page 255)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 255
8. Enter the name of the system file on the switch that you want to upload
to your computer. You can specify only one file. You cannot use
wildcards in the file name. If the file is stored on a flash memory card,
precede the name with “cflash:”.
The following prompt is displayed:
You are going to invoke the Xmodem download utility.
Do you wish to continue? [Yes/No]
Note: Please select 1K Xmodem protocol for faster
download.
Note
The transfer protocol must be Xmodem or 1K Xmodem.
9. Type Y for Yes.
The following message is displayed:
Use Hyper Terminal's 'Transfer/Receive File' option to
select Protocol
Note: Please select '1K Xmodem' protocol for faster
upload...
10. Begin the file transfer.
Steps 11 through 14 illustrate how you would upload a file using the
Hilgraeve HyperTerminal program.
11. From the HyperTerminal main window, select Receive File from the
Transfer menu, as shown in Figure 75.
Figure 75. HyperTerminal Window