Allied Telesis AT-S63 - Manual (Page 239)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Operations 239
To upload the AT-S63 management software image from a master switch
to other switches in the same enhanced stack, perform the following
procedure:
1. From the Main Menu, type 8 to select Enhanced Stacking.
The Enhanced Stacking menu is shown in Figure 17 on page 88.
2. From the Enhanced Stacking menu, type 2 to select Stacking
Services.
Note
The “2 - Stacking Services” selection is only available on a master
switch.
The Stacking Services menu is shown in Figure 18 on page 89.
3. From the Stacking Services menu, type 1 to select Get/Refresh List of
Switches. The master switch polls the subnet for other enhanced
stacking switches in the same enhanced stack and displays the
switches in the Stacking Services menu.
4. Type 4 to select Download Image/Bootloader File.
The following prompt is displayed:
Remote switches will reboot after load is complete.
Enter the list of switches ->
5. Enter the number (Num column in the menu) of the AT-9400 Series
switch whose software you want to update. You can specify more than
one switch at a time (for example, 2,4,5).
Note
You cannot download AT-S63 software onto any type of enhanced
stacking switch other than AT-9400 Series switches.
The following prompt is displayed:
Do you want to show remote switch burning flash -> [Yes/
No]
6. You can respond with Yes or No to this prompt. It does not affect the
download.
The following prompt is displayed:
Do you want confirmation before downloading each switch -
> [Yes/No]