Allied Telesis AT-S63 - Manual (Page 634)

Chapter 25: Port-based and Tagged VLANs
634 Section VI: VLANs
of 24. Then you need to be sure that the uplink and downlink ports
connecting the switches together are either tagged or untagged members
of the NMS VLAN. You also need to specify the NMS VLAN as the
management VLAN on each switch using the AT-S63 management
software. Finally, you must be sure to connect your management station
to a port on a switch that is a tagged or untagged member of the
management VLAN.
The best approach to changing the management VLAN on the switches of
an enhanced stack is to establish a local management session with each
switch and adjust it through the local session, rather than through
enhanced stacking. Changing a switch’s management VLAN through
enhanced stacking ends your management session. You will not be able
to reestablish the session until you change the management VLAN on the
master switch.
Note
You cannot specify a management VLAN when the switch is
operating in a multiple VLAN mode.
To specify a management VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 207 on page 612.
2. From the VLAN Configuration menu, type 3 to select Management
VLAN.
The following prompt is displayed:
Enter Management VLAN ID [1 to 4094] ->
3. Specify the VID of the VLAN that is to function as the management
VLAN. This VLAN must already exist on the switch.
The following prompt is displayed:
SUCCESS
Press any key to continue ...
4. Press any key.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.