Allied Telesis AT-S63 - Manual (Page 60)

Chapter 3: Basic Switch Parameters
60 Section I: Basic Operations
Model Name
Model name of the AT-9400 Series switch. You cannot change this
setting.
Subnet Mask
Subnet mask assigned to the switch. To change the subnet mask, see
“Configuring the IP Address, Switch Name, and Other Basic
Parameters” on page 54.
Serial Number
Serial number of the switch. You cannot change this setting.
Gateway
Gateway assigned to the switch. To change the gateway, see
“Configuring the IP Address, Switch Name, and Other Basic
Parameters” on page 54.
System Up Time
The number of days, hours, minutes, and seconds the switch has been
operational. You cannot change this setting.
Bootloader and Build Date
The version of the bootloader software and the date it was built.
Application and Build Date
The version of the AT-S63 management software that the switch is
currently running and the date it was built.
System Name
The name assigned to the switch. To change the name, see
“Configuring the IP Address, Switch Name, and Other Basic
Parameters” on page 54.
Administrator
The administrator of the switch. To change the administrator’s name,
see “Configuring the IP Address, Switch Name, and Other Basic
Parameters” on page 54.
Location
The location of the switch. To change the location information, see
“Configuring the IP Address, Switch Name, and Other Basic
Parameters” on page 54.
For information about selection H, System Hardware Status, refer to
“Displaying System Hardware Information” on page 78. For
information about selection U, Uplink Information, refer to “Displaying
Uplink Port Information” on page 80.