Snmpv3 configuration example – Allied Telesis AT-S63 User Manual
Page 428
Advertising
Chapter 22: SNMPv3
428
Section IV: SNMPv3
Tables to configure SNMPv1 and SNMPv2c communities, start with the
SNMPv3 Community Table. See “Configuring the SNMPv3 Community
Table” on page 505.
Note
Allied Telesyn recommends that you use the procedures described
in Chapter 5, “SNMPv1 and SNMPv2c” on page 95 to configure the
SNMPv1 and SNMPv2c protocols.
SNMPv3
Configuration
Example
You may want to have two classes of SNMPv3 users—Managers and
Operators. In this scenario, you would configure one group, called
Managers, with full access privileges. Then you would configure a second
group, called Operators, with monitoring privileges only. For a detailed
example of this configuration, see Appendix B, “SNMPv3 Configuration
Examples” on page 885.
Advertising