Allied Telesis AT-S63 - Manual (Page 193)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 193
Displaying the Route Table
The routing table is used by the switch when a remote node specified in a
management command is not on the same physical network as the switch.
The table contains the IP address of the next hop to reaching the remote
network or device. For example, the switch might refer to the table if you
instructed it to download a new AT-S63 image file from a network server
that was on a different physical network.
To display the route table, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 54.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 7 on page 61.
3. From the System Utilities menu, type 6 to select Networking Stack.
The Networking Stack menu is shown in Figure 55 on page 189.
4. From the Networking Stack menu, type 4 to select Display Route
Table.
The Display Route Table menu is shown in Figure 57.
Figure 57. Display Route Table Menu
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
Display Route Table
Destination Mask Next Hop Interface
---------------------------------------------------------------
127.0.0.0
255.0.0.0 127.0.0.1 loopback
169.254.0.0 255.255.0.0 169.254.37.1 eth0
169.254.37.1 255.255.255.255 127.0.0.1 loopback
U - Update Display
R - Return to Previous Menu
Enter your selection?