Allied Telesis AT-S63 - Manual (Page 61)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Operations 61
Rebooting a Switch
This procedure reboots the switch.
Note
Any configuration changes not saved are lost after the switch
reboots. To save your configuration changes, return to the Main
Menu and type S to select Save Configuration Changes.
To reboot the switch, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 54.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 7.
Figure 7. System Utilities Menu
Note
Item 1 - File Operations, is described in Chapter 11, ”File System” on
page 203. Item 2 - Downloads and Uploads is described in Chapter
12, ”File Downloads and Uploads” on page 229. Ping a Remote
System, item 3, is described in “Pinging a Remote System” on
page 75. Reset to Factory Defaults, item 4, is described in
“Returning the AT-S63 Management Software to the Factory Default
Values” on page 76. Item 6, Networking Stack, is described in
Chapter 10, ”Networking Stack” on page 187.
Allied Telesyn Ethernet Switch AT-94xx - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2005
System Utilities
1 - File Operations
2 - Downloads and Uploads
3 - Ping a Remote System
4 - Reset to Factory Defaults
5 - Reboot the Switch
6 - Networking Stack
R - Return to Previous Menu
Enter your selection?