Allied Telesis AT-S63 - Manual (Page 547)

AT-S63 Management Software Menus Interface User’s Guide
Section V: Spanning Tree Protocols 547
4 - Edge Port
This parameter defines whether the port is functioning as an edge port.
The possible settings are Yes and No. For an explanation of this
parameter, refer to “Point-to-Point and Edge Ports” on page 531.
C - Check Migration To RSTP on Selected Ports (MCHECK)
The MCHECK parameter is displayed only when RSTP is enabled.
This parameter resets an RSTP port, allowing it to send RSTP BPDUs.
When an RSTP bridge receives STP BPDUs on an RSTP port, the port
transmits STP BPDUs. The RSTP port continues to transmit STP
BPDUs indefinitely. Type C to reset the MSTP port to transmit RSTP
BPDUs.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Displaying the
RSTP Port
Configuration
To display the RSTP port configuration, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 178 on
page 535.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The RSTP menu is shown in Figure 179 on page 537.
3. From the RSTP menu, type P to select RSTP Port Parameters.
The RSTP Port Parameters menu is shown in Figure 184 on page 545.
4. From the RSTP Port Parameters menu, type 2 to select Display RSTP
Port Configuration.