Allied Telesis AT-S63 - Manual (Page 76)

Chapter 3: Basic Switch Parameters
76 Section I: Basic Operations
Returning the AT-S63 Management Software to the Factory Default
Values
The procedure in this section returns all AT-S63 management software
parameters to the default values. Please note the following before you
perform this procedure:
ˆ Returning all parameter settings to their default values also deletes
any port-based or tagged VLANs you created on the switch.
ˆ This procedure does not delete files from the AT-S63 file system. To
delete files, refer to Chapter 11, ”File System” on page 203.
ˆ This procedure does not delete any encryption keys stored in the key
database. To delete encryption keys, refer to “Deleting an Encryption
Key” on page 771.
ˆ Returning a switch to its default values does not alter the contents of
the active boot configuration file. To reset the file back to the default
settings, you must reestablish your management session after the
switch reboots and then select Save Configuration changes.
Otherwise the switch reverts back to the previous configuration the
next time you reset the switch.
Note
The AT-S63 management software default values are listed in
Appendix A, “AT-S63 Management Software Default Settings” on
page 853.
To return the AT-S63 management software to the default settings,
perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 54.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 7 on page 61.
3. From the System Utilities menu, type 4 to select Reset to Factory
Defaults.
The following prompt is displayed:
Do you want to reset to factory defaults? [Yes/No] ->
4. Type Y for yes or N to cancel the procedure.