Leica Biosystems LPC Software installation - Manual (Page 103)

103
LabeLase ® Producer - Installation
3.3.3 Supervisor password
Fig. 28
To keep unauthorized personnel out of the configuration and maintenance
functions of the program, you may set a supervisor password. This pass-
word is required to enter the supervisor mode of operation.
To set the password you must first enter the current password. If the pass-
word is not currently set, leave this field blank.
Enter the new password, then re-enter it to verify. As you type the pass-
word, only asterisks are displayed.
After you click the "OK" button, the password will be set.
3.3.4 Units of measure
The program is capable of handling both English and Metric
units of measure. You can set the units of measure as
needed for your location. The unit setting affects the field
locations in a layout, the printer configuration settings, user
preferences, etc.
Note that loading a layout that was created with different
units than your setting will change your units setting to the
layout’s setting.
Fig. 29
3. User Interface