Leica Biosystems LPC Software installation - Manual (Page 21)

21
LabeLase ® Producer - Installation
5e
When you have selected or found the port to which the printer is connected,
click "Next" to continue.
If you have used the "Find" button and the program has found and communi-
cated with the printer, you can advance to Step 9 to install the version of
LabeLase® Producer.
3.3.2 USB port
6
In order to connect the printer to your PC’s USB port, you need a standard
USB cable. The printer is shipped with this cable if the USB option has been
installed on it.
Fig. 15
6a
Locate the USB port on the back of the printer as shown in the figure below.
Fig. 16
Connect one end of the USB cable to
this port on the printer, but DO NOT
connect the other end of the cable to
your PC.
It is important that you wait
until instructed to connect
the USB cable to your PC.
Switch the printer (16) ON and wait for
it to initialize.
16

3. Installation