Leica Biosystems LPC Software installation - Manual (Page 134)

134 Software Installation Manual, Revision 2 - 03/2010
When you specify a bitmap, the bitmap is loaded and contained in the layout
itself. The link to the original bitmap file is no longer needed once the file is
initially loaded. This makes it easy to send the layout to someone else with-
out having to worry about the graphics files and their paths.
An Export button is provided to allow you to save the bitmap to a file. You
will be asked to specify a filename for the destination bitmap.
Line Field Editor
Fig. 63
Each line field is defined by several pieces of information that you must sup-
ply. This information includes:
X - The X coordinate of the lower left corner of the line is specified here.
Note that this value is already filled in for you based on where you clicked
the mouse.
Y - The Y coordinate of the lower left corner of the line is specified here.
Note that this value is already filled in for you based on where you clicked
the mouse.
Height - Defines the vertical thickness of the line (Y dimension).
Width - Defines the horizontal dimension of the line (X dimension).
Rotation - Specifies the number of degrees to rotate the line. Enter 0, 90, 180
or 270 or use the up/down control to change the field. Note that the rotation
of the field is relative to the X/Y coordinate of the lower left of the line.
Reverse Image - This checkbox specifies that any other field enclosed by
this line should be "reversed" (black into white, white into black.)
3. User Interface