Leica Biosystems LPC Software installation - Manual (Page 40)

40 Software Installation Manual, Revision 2 - 03/2010
7b
After you selected Ethernet as your connection type, you will see a screen
that looks similar to the one shown below.
Even if you use an Ethernet network connection to connect the printer to your PC, the LabeLase®
Producer software still expects to communicate with the printer via a serial port (COM port). For this to
work, the software you have installed, called Redirector, creates a "virtual" serial port, which convinc-
es the Producer that it is a serial port, though it is actually using an Ethernet port.
When you are ready to continue with the installation, click "Next".
Fig. 37
3. Installation