Leica Biosystems LPC Software installation - Manual (Page 91)

91
LabeLase ® Producer - Installation
The "Open" dialog opens when you select the "Open" menu item in the File menu or click the
"Open" button in the Main form. This dialog allows you to open a cassette layout file to be
opened. If you select a file from the list, a preview is displayed in the right-hand section of the
dialog to help you select the correct file.
You may select any layout file that may reside in any folder on your hard disk drive, on a CD/
DVD, or anywhere in a network folder (assuming your PC is connected to a network that allows
file sharing.)
Clicking the "Preview" button in the upper right corner of the dialog will open a new window
showing the full size layout image.
3.2.2 Supervisor/Operator
The supervisor must enter the correct password, then click "OK". If an incorrect password is
entered, an error message is displayed.
Once the correct password is entered, the program will enter the Supervisor mode of operation
and all functions will be enabled. To go back to the operator mode, pull down the File menu and
notice that "Supervisor" has been replaced by "Operator". No password is required to switch
back to operator mode.
Fig. 19
If the pro-
gram is run-
ning in op-
e r a t o r
mode, ac-
cess to
some func-
tions is not
possible, in
which case
the menu
item ap-
pears as
" S u p e r v i -
sor".
When the Supervisor menu is selected, the password entry form appears, in which the supervi-
sor enters the corresponding password for switching between modes.
3. User Interface