Leica Biosystems LPC Software installation - Manual (Page 87)

87 Leica LP C
3.1.9 Maintenance menu
The Maintenance menu is only available when in
the Supervisor mode of operation and provides
several features that aid in the setup of the print-
er and diagnosis of any problems you may en-
counter. Note that under most circumstances, it
will not be necessary to access these functions.
If you must use these functions, do so only under
the direct supervision of factory-trained person-
nel.
Motor Diagnostics - This menu item will activate
the "Motor Diagnostics" form that allows the su-
pervisor to start up the printer motor slowly as
part of a diagnostic procedure.
Fig. 12
View Printer I/O - This menu item will activate the "Printer I/O Monitor" form,
which allows the supervisor to view the Input and Output signals of the cas-
sette printer.
Digital to Analog Converter - This menu item will activate the "Digital to
Analog Converter Monitor" form, which allows the supervisor to manipulate
the D/A converter that controls the printer's galvanometer / mirror.
3.1.10 Help menu
The Help menu provides access to
the program's built-in help facility,
as well as to information about the
program itself.
Contents - This menu item will acti-
vate the Windows Help for the
Producer CL program, including in-
dexed search, tutorials, etc.
Fig. 13
3. User Interface