Leica Biosystems LPC Software installation - Manual (Page 39)

39
LabeLase ® Producer - Installation
IP address
Your printer must have a unique IP address on your network.
The Network Administrator generally provides the IP address, subnet mask,
and gateway. The IP address must be within a valid range, unique to your
network, and in the same subnet as your PC.
IP address: _______ _______ _______ _______
Subnet mask: _______ _______ _______ _______
Gateway: _______ _______ _______ _______
There are two ways to assign an IP address to your printer. If your network
administrator assigns IP addresses manually (called a static address), ask
your network administrator for the information you need.
If devices on your network obtain their IP addresses from a DHCP server
(called a dynamic address), then you won’t need to know what the
IP address, subnet mask or gateway are as the printer will get them auto-
matically.
16

Locate the Ethernet jack (RJ45) on the
back of the printer as shown in the fig-
ure below.
Connect one end of the Ethernet cable
to this jack on the printer, and the oth-
er end to a network switch or hub.
You may instead connect the printer
directly to your PC with a cross-over
cable (no switch or hub).
Switch the printer ON (16) and wait for
it to initialize.
Fig. 36
3. Installation