Leica Biosystems LPC Software installation - Manual (Page 133)

133
LabeLase ® Producer - Installation
Graphic Field Editor
Fig. 62
Each graphic field is defined by several pieces of information that you must
supply. This information includes:
BMP Filename - You must specify the file pathname of the graphic image. A
Browse button is provided that will show an Open dialog for searching the
file system for the desired BMP file. You may load a file from your PC's hard
drive, a CD/DVD or a network folder.
X - The X coordinate of the lower left corner of the graphic is specified here.
Note that this value is already filled in for you based on where you clicked
the mouse.
Y - The Y coordinate of the lower left corner of the graphic is specified here.
Note that this value is already filled in for you based on where you clicked
the mouse.
X Scale - The horizontal scaling factor. This number may be less than 1.0 to
scale the image down, or greater than 1.0 to scale the image up.
Y Scale - The vertical scaling factor. This number may be less than 1.0 to
scale the image down, or greater than 1.0 to scale the image up. Note that if
the X and Y scaling factors are different (this is allowed) then the graphic
image will be distorted. This may or may not be a desired result.
Rotation - The Rotation value specifies the number of degrees to rotate the
graphic image. Enter 0, 90, 180 or 270 or use the up/down control to change
the field. Note that the rotation of the field is relative to the X/Y coordinate of
the lower left of the graphic.
3. User Interface