Leica Biosystems LPC Software installation - Manual (Page 136)

136 Software Installation Manual, Revision 2 - 03/2010
Ellipse Field Editor
Fig. 65
Each ellipse field is defined by several pieces of information that you must
supply. This information includes:
X - The X coordinate of the lower left corner of the enclosing rectangle is
specified here. Note that this value is already filled in for you based on
where you clicked the mouse.
Y - The Y coordinate of the lower left corner of the enclosing rectangle is
specified here. Note that this value is already filled in for you based on
where you clicked the mouse.
Height - Defines the vertical dimension of the enclosing rectangle (Y dimen-
sion).
Width - Defines the horizontal dimension of the enclosing rectangle (X di-
mension).
Rotation - Specifies the number of degrees to rotate the ellipse. Enter 0, 90,
180 or 270 or use the up/down control to change the field. Note that the ro-
tation of the field is relative to the X/Y coordinate of the lower left of the en-
closing rectangle.
Thickness - Defines the thickness of the ellipse outline.
Note that if you set the Height and Width fields to the same
value, the result will be a perfect circle.
3. User Interface