MTS Series 793 User Manual
Page 120
MTS Series 793 Tuning and Calibration
How to Perform Advanced Tuning Techniques
Tuning Procedures
120
Stabilization filters
Stabilization filters are available for control modes equipped with stabilization
resources and include:
•
A 1 Hz High-pass filter that attenuates signals below 1 Hz.
•
A Band-pass filter that attenuates signals outside of a user-definable band.
To select a Stabilization filter, select and set up the desired filter type of 1 Hz
High-pass or Band-pass.
–
For Band-pass filters, set the frequency band with the Frequency
Limits control.
Note
Some systems with a higher actuator frequency may benefit by selecting
the following Frequency Limits: a low cut-off frequency that is
approximately the actuator frequency and a high cut-off frequency
approximately 5-10 times the actuator frequency.