MTS Series 793 Utility Software - Manual (Page 116)

To avoid running out of flash memory, make sure that the backup directory does not contain
an excessive number of files.
4. If desired, select Backup User Files to copy the user files in the controller to the servicing PC.
The files are copied to a designated root directory destination or to a new folder.
5. Perform other operations as desired.
6. In the Next Controller Boot Mode selection list, select Standalone, Standalone/Net, or Automated,
as appropriate.
7. Reboot the controller. Press CMT’s Reboot Controller button, or press the <<Reboot>> key on
the controller’s front panel. The controller will boot in the selected boot mode.
How to Register a FlexTest SE Controller for Automation
1. Launch CMT and verify that all controllers appear in the main window as connected.
2. Select the controller that you want to register.
3. Register the selected controller.
a) Select Register Controller to create a controller-specific folder in the “Controllers” directory
on the servicing PC.
b) The hwi file and config folder are then copied to this new folder from the controller being
registered.
4. In the Next Controller Boot Mode selection list, select the desired boot mode.
5. Perform other operations as desired.
6. Reboot the controller. Press CMT’s Reboot Controller button, or press the <<Reboot>> key on
the controller’s front panel. The controller will boot in the selected boot mode.
How to Unregister a FlexTest SE Controller
1. Launch CMT and verify that all controllers appear in the main window as connected.
2. Select the controller that you want to unregister.
3. Unregister the selected controller.
a) Select Unregister Controller.
b) The controller-specific directory is optionally removed from the servicing PC.
You may want to set the controller to boot in the Stand-alone boot mode rather than the
Automation boot mode after you unregister it.
102 MTS Series 793 Utility Software
Controller Management Tool