MTS Series 793 Utility Software - Manual (Page 48)

Description Item
Changing this name may invalidate existing station
configurations.
Name: Describes this resource as it will appear in Station Builder
resource lists when opened against an .hwi file. Analog Output icons
Connector: Both Analog Outputs are available on the “DA
Output” connector (located on the front of the 494.04 chassis).
Changing this name may invalidate existing station
configurations.
Connector: J25. Hydraulic Interface icon (HPU)
HPU with HSM: True: Indicates the system’s HPU supplies
HSMs. False: used for HPU only systems (allows HPU selection
to be available to Station Builder).
First On: True: Indicates that the first HSM turned on activates
the HPU.
False: Setting First On and Last Off to False allows the HPU to
turn on independent of HSM power.
Setting First On and Last Off to True allows HSM Low selection
to activate HPU High without pressing the HPU buttons.
Last Off: True: Causes the last HSM turned off to turn off the
HPU.
The First On/Last OFF settings are only available if the HPU
with HSM setting is True.
Name: Describes this resource as it will appear in Station Builder
resource lists when opened against an .hwi file.
Changing this name may invalidate existing station
configurations.
Visible: True: Indicates whether or not the HPU button is visible
on the control panel. Changing Visible to False turns off the
HPU button display on the Station Manager window, provided
both First On and Last Off are True.
The Visible setting is only available when both the First On and
First Off settings are set to True.
Connector: J28 Hydraulic Interface icon (HSM)
Name: Describes the hardware resource as it will appear in
Station Builder resource lists.
Changing this name may invalidate existing station
configurations.
(Should this be read only?)Type: Solenoid, Proportional, On/Off
Solenoid.
If you select On/Off Solenoid, only two HSM control buttons
(Off/On) will appear on the Station Manager Station Controls
34 MTS Series 793 Utility Software
HWI Hardware Settings