MTS Series 793 Utility Software - Manual (Page 59)

Description Item
Changing this name may invalidate existing station configurations.
Connector: Not applicable.
Model 498.71 GRES II Board Settings
This card is compatible with FlexTest IIm controllers.
Description Item
The Model 498.71 GRES II board supports both the Remote Station
Controller (RSC) and the temperature controller. It must be added 498.71 GRES II circuit
board icon
to your system when using either of these components before the
components are installed in the chassis. The GRES II board
communicates to the RSC or temperature controller via a serial
transition card located to the rear of the chassis.
Address: Describes the proximity of the circuit board within the
chassis. This value is generated during initialization, and should be
changed only if the value read in from an existing .hwi file is in error.
Slot: Specifies which slot the circuit board occupies in the chassis.
Clock Type: Master, Dependent.
For Master Clocks
Clock Mode: Decimal, Binary.
System Rate: 1024, 2048, 4096 and 6144 Hz (binary).
The System Rate must be an integer multiple of the Medium System
Rate.
Medium System Rate: Must be an integer multiple of the Low System
Rate.
The Low System Rate is always set at 25.6. The Medium System
Rate is typically 256.
Name: Describes this resource as it will appear in Station Builder
resource lists when opened against an .hwi file. Digital Input/Output icons
Changing this name may invalidate existing station configurations.
Channel: Not applicable.
MTS Series 793 Utility Software 45
HWI Hardware Settings