MTS Series 793 Utility Software - Manual (Page 75)

Model 494.45 8-Input A/D Converter HWI Settings
Description Item
Describes the eight-channel analog-to-digital converter mezzanine
card. 494.45 8-Input A/D
mezzanine card icon
Application Attribute: Not applicable Properties tab
Each analog input has a drop-down menu where you can select one
of the following input options: Channels tab
Specifies an externally conditioned signal in the range of +/-10V. High Level
Excludes inputs to the selected channel. No Channel
Name: Describes this resource as it will appear in Station Builder
resource lists when opened against an .hwi file. Analog Input icon
Changing this name may invalidate existing station configurations.
Application Attribute: Not applicable
Filter: This is the frequency where the filter, selected in the Filter
Type box, attenuates the signal by 3 dB. A setting of zero disables
the filter.
Connector: Describes the I/O Carrier board connector that joins the
resource to the chassis. This will likely move up to the daughter level.
Filter Type: Used to select the type of filter used to filter the digital
output of the A/D Converter. Selections include: Disabled, Bessel,
Butterworth, and Elliptical. (Default=Bessel, 300 Hz.)
Model 494.46 8-Output D/A Converter Card HWI Settings
Description Item
Describes the eight-channel digital-to-analog converter mezzanine
card. 494.46 8-Input D/A
mezzanine card icon
Application Attribute: Not applicable Properties tab
Each analog output has a drop-down menu where you can select
one of the following output options: Channels tab
Specifies an analog output in the range of +/-10V. High Level
Excludes outputs to the selected channel. No Channel
MTS Series 793 Utility Software 61
HWI Hardware Settings