MTS Series 793 Utility Software - Manual (Page 73)

How to Add a DI/O Load Washer to a Model 494.21 Card
1. Add a 494.21 card resource to the .hwi file.
2. Right-click the DUC icon and select Add DIO Load Washer.
A DI/O Load Washer icon appears below the DUC icon.
3. Click the DI/O Load Washer icon and verify that the hardware resource names that appear in
the Zero Bit, One Bit, and Enable boxes are correct.
4. If the hardware resource names are not correct, change the hardware resources names in
these boxes to match the Digital Inputs where these signals are physically connected.
5. If you want to assign custom names to each range, use the Hwi File Editor application to change
the range names to match the range names that you will use in the Station Manager application.
Note:
The range names that appear in the DI/O Load Washer Properties tab must match the
range names assigned in the Sensor tab in the Station Manager application.
How to Add a Serial Load Washer to a Model 494.21 Card
1. Add a serial comm resource to the .hwi file .
2. Right-click the DUC icon and select Add Serial Load Washer.
A Serial LoadWasher icon appears below the DUC icon.
3. Configure the Serial LoadWasher.
a) Click the Serial LoadWasher icon.
b) From the Serial Port drop-down list, select the serial port where the loadwasher is connected.
c) Verify the scale settings are correct for the loadwasher that you are using.
MTS Series 793 Utility Software 59
HWI Hardware Settings