MTS Series 793 Utility Software - Manual (Page 51)

Description Item
Type:
Off-high–only two HPU control buttons (Off/High) will
appear on the Station Manager Station Controls panel.
Off-low-high–three HPU control buttons (Off/Low/High)
will appear on the Station Manager Station Controls
panel.
First On:
True: Indicates that the first HSM turned on activates the
HPU.
False: Setting First On and Last Off to False allows the
HPU to turn on independent of HSM power.
Setting First On and Last Off to True allows HSM Low
selection to activate HPU High without pressing the HPU
buttons.
Last Off: True: Causes the last HSM turned off to turn
off the HPU.
The First On/Last OFF settings are only available if the
HPU with HSM setting is True.
Visible:
True: the HPU button is visible on the Station Manager
control panel.
False: Removes the HPU button display from the Station
Manager control panel, provided both First On and Last
Off are True.
The Visible setting is only available when both the First
On and First Off settings are set to True.
Name: Describes the hardware resource as it will appear
in Station Builder resource lists. Hydraulic Interface icon (HSM)
Changing this name may invalidate existing station
configurations.
Connector: J28
(Should this be read only?)Type: Solenoid, Proportional,
On/Off Solenoid.
Solenoid: three HSM control buttons (Off/Low/High) will
appear on the Station Manager Station Controls panel.
On/Off Solenoid: only two HSM control buttons (Off/On)
will appear on the Station Manager Station Controls
panel. For the other types, three HSM control buttons
will appear (Off/Low/High).
Proportional: you configure the proportional output with
the controller software. The output signal can be ramped
MTS Series 793 Utility Software 37
HWI Hardware Settings