MTS Series 793 Utility Software - Manual (Page 44)

Description Item
Slot: Specifies which slot the circuit board occupies in the
chassis.
Clock Type: Master/Dependent.
For Master Clocks
System Rate: 1024, 2048, 4096 and 6144 Hz (binary).
Note:
The System Rate must be an integer multiple of the
Medium System Rate.
Medium System Rate: Must be an integer multiple of the
Low System Rate.
Note:
The Low System Rate is always set at 25.6. The
Medium System Rate is typically 256.
Mezzanine: describes the mezzanine cards that are
installed on the ADDA board. Mezzanines tab
Model 498.71 GRES II Board Settings
This card is compatible with FlexTest IIm controllers.
Description Item
The Model 498.71 GRES II board supports both the Remote Station
Controller (RSC) and the temperature controller. It must be added 498.71 GRES II circuit
board icon
to your system when using either of these components before the
components are installed in the chassis. The GRES II board
communicates to the RSC or temperature controller via a serial
transition card located to the rear of the chassis.
Address: Describes the proximity of the circuit board within the
chassis. This value is generated during initialization, and should be
changed only if the value read in from an existing .hwi file is in error.
Slot: Specifies which slot the circuit board occupies in the chassis.
Clock Type: Master, Dependent.
For Master Clocks
Clock Mode: Decimal, Binary.
System Rate: 1024, 2048, 4096 and 6144 Hz (binary).
The System Rate must be an integer multiple of the Medium System
Rate.
30 MTS Series 793 Utility Software
HWI Hardware Settings