Rockwell Automation 1512A MV Controllers - 800A One-High Cabinet - Manual (Page 37)

3-12 Installation – Arc Resistant (ArcShield)
1512A-UM102B-EN-P –June 2013
Figure 3.11 – Power Bus Bars
A T T E N T I O N A T T E N T I O N
To avoid shock hazards, lock out incoming power
(see page 5-3) before working on the equipment.
Verify with a hot stick or appropriate voltage
measuring device that all circuits are voltage free.
Failure to do so may result in severe burns, injury
or death.
I M P O R T A N T I M P O R T A N T
The current transformers may be positioned for top
or bottom cable exit. Follow the appropriate
procedure described for your starter configuration.
I M P O R T A N T I M P O R T A N T
Load cable size should not exceed 1-1000 MCM, 2-
750 MCM, 3-500 MCM or 4-500 MCM per
phase.
Note: Refer to Dimensional Drawings provided with order
Documentation for additional details related to cabinet
Floor plan.
1) Complete the Power Lockout procedure (see page 5-3).
2) Remove the appropriate cable conduit opening plate(s) from the
cabinet (see Figures 3.12 and 3.13). The plate may be punched or cut
to mount conduit.
Load Cable Connections