Rockwell Automation 1408-EMxx PowerMonitor 1000 Unit - Manual (Page 19)

Rockwell Automation Publication 1408-UM001D-EN-P - September 2013 19
PowerMonitor 1000 Overview Chapter 1
Edit a Parameter
To edit a parameter, do the following:
• Press <up> or <down> to change the highlighted digit.
• Press <up> and <down> together to move the highlight cursor one place
to the left, and press <up> or <down> to set the selected digit’s value.
Continue in the same way until the correct value is entered then press <enter>
when done.
Setup Example
This example steps through setting the unit date to demonstrate use of the display
and buttons to navigate through the setup menu and make changes to parameters.
1. Navigate to the initial screen.
The screen shown is the top level screen. If it is not present, press <escape>
until it appears.
If you press <escape> once too often, the To Default Screen? message
appears. Press <escape> once more if this occurs.
2. Press <enter> and this screen appears.
PowerMonitor 1000
RS-485 STATUS
RX TX Mod Net
Power And
Energy Management
Solutions
PowerMonitor 1000
RS-485 STATUS
RX TX Mod Net
Display