Rockwell Automation 1408-EMxx PowerMonitor 1000 Unit - Manual (Page 63)

Rockwell Automation Publication 1408-UM001D-EN-P - September 2013 63
Explicit Messaging Chapter 5
Message setup is complete for Serial communication.
4. Click the MultiHop tab if configuring Ethernet communication.
Communication Type Parameter Choice
Ethernet Communication Command Select the appropriate message type according to Message Type
on page 54 .
Data Table Address (This Controller) Read: This is the controller tag in which to store the data being
read.
Write: This is the controller tag that stores the value to be written
to the power monitor.
Size in Elements This is the number of elements being read or written to. If you are
performing a single element read or write, then this value should
be 1. If you are performing a multiple element read or write, then
this should be the number of elements after the source element
that you wish to read or write.
Port Number 2
Data Table Address (Target Device) Refer to Appendix A for the address of the specific data value
you’re reading or writing to.
MultiHop Yes
Serial Communication Command Select the appropriate message type according to Message Type
on page 54 .
Data Table Address Read: This is the controller tag in which to store the data being
read.
Write: This is the controller tag that stores the value to be written
to the power monitor.
Size in Elements This is the number of elements being read or written to. If you are
performing a single element read or write, then this value should
be 1. If you are performing a multiple element read or write, then
this should be the number of elements after the source element
that you wish to read or write.
Port Number 0
Data Table Address (Target Device) Refer to Appendix A for the address of the specific data value
you’re reading or writing to.
Local Station Address This is the serial node address of your power monitor.
Local / Remote Local