Rockwell Automation 1408-EMxx PowerMonitor 1000 Unit - Manual (Page 9)

Rockwell Automation Publication 1408-UM001D-EN-P - September 2013 9
Chapter
1
PowerMonitor 1000 Overview
Safety Follow these advisories when using this product.
ATTENTION: Only qualified personnel, following accepted safety
procedures, should install, wire, and service the power monitor
and its associated components. Before beginning any work,
disconnect all sources of power and verify that they are de-
energized and locked out. Failure to follow these instructions may
result in personal injury or death, property damage or economic
loss.
ATTENTION: Never open a current transformer (CT) secondary
circuit with primary current applied. Wiring between the CT’s and
the power monitor should include a shorting terminal block in the
CT secondary circuit. Shorting the secondary with primary current
present allows other connections to be removed if needed. An
open CT secondary with primary current applied produces a
hazardous voltage, which can lead to personal injury, death,
property damage or economic loss.
IMPORTANT The power monitor is neither designed for, nor intended for, use as a
circuit protective device. Do not use this equipment in place of a
motor overload relay or circuit protective relay.