Panel/wall mounting – Rockwell Automation 1440-VAD02-01RA XM-123 Aeroderivative Module User Manual
Page 24
Advertising
Publication GMSI10-UM003D-EN-P - May 2010
16
5. Gently push the side connector into the side of the neighboring terminal
base to complete the backplane connection.
Panel/Wall Mounting
Installation on a wall or panel consists of:
•
laying out the drilling points on the wall or panel
•
drilling the pilot holes for the mounting screws
•
installing the terminal base units and securing them to the wall or panel
Use the following steps to install the terminal base on a wall or panel.
Advertising