Metrohm IC Net 2.0 - Manual (Page 124)

7 Methods
IC Net 2.0 116
Integration events for peak start/end
Set peak start Force the beginning of a new peak. If a
peak is available at the moment of the
event it is either rejected (upslope) or ter-
minated (downslope).
Set peak end
Force peak end at the time of the event.
Upslope peaks are rejected (except those
born by
Set peak start
event), downslope
peaks are terminated.
Stop single peak mode
Disable peak end detection. All peaks of
any group after this event will be treated as
one peak. The group end will be treated as
peak end.
Start single peak mode Set normal detection mode, when valley
causes perpendicular drop or skim line
separation.
Split peak Terminates the current peak and starts a
new one.
Integration events for baseline
Enable valley-to-valley Disable valley-to-valley
Enable valley-to-valley Disable perpendicular drop peak separa-
tion. All peaks are considered to be base-
line-separated. The bottom of the valley
becomes the baseline point.
Disable valley-to-valley Enable perpendicular drop peak separation
(default setting).
Set horizontal Set back hori- Set normal
baseline zontal base baseline