5 metrohm pc board 5.6 global timer, 1 timer icon, 2 timer program – Metrohm IC Net 2.0 User Manual
Page 59: 5 metrohm pc board, 6 global timer
5.5 Metrohm PC Board
IC Net 2.0
51
5.5
Metrohm PC Board
The 2.714.0310 Metrohm PC Board Interface is a two channel
Analog-to-Digital Converter (often abbreviated as ADC) to ac-
quire two analog signals from two different detectors simultane-
ously or time independent (e.g. conductivity detection and UV
detection).
One or two PC Boards can be installed in the same PC: PC
Board 1 is the first interface, PC Board 2 is the second interface
installed in the PC. They differ in different jumper settings on the
board. The «IC Net» program is the successor for the former «IC
Metrodata for Windows» program used to work with the PC
Boards.
The 6.2128.140 cable is used to connect the analog output of the
732 IC Detector (or another detector) and the contact closure
output of the 733 IC Separation Center to the Metrohm PC Board.
The Metrohm PC Board must be installed with the new system
wizard or by using the
<Install device>
option of the
Workplace
window (see section 5.1.2). However, there is no PC Board icon
on the toolbar after installation. The PC Board can only be seen in
the
Workplace
window opened with
Options / Devices setup
. By
double-clicking the
MeBoard1
or
MeBoard2
item, the
MeBoard#
window opens with the following tabs:
Device settings
Manual control and startup values for PC
Board (it is recommended not to change
any of these parameters!).
Links
Window for COM port selection and set-
tings (it is recommended not to change any
of these parameters!).
For detailed information about the Metrohm PC Board see on-line
help and Instructions for Use for «IC Metrodata for Win-
dows».
5.6
Global timer
5.6.1
Timer icon
The global timer is used for programming system tasks which are
started automatically daily or once at the desired time. The
Global
timer icon
is available on the toolbar if the
Timer
has been installed
with the new system wizard or by using the
<Install device>
option
of the
Workplace
window (see section 5.1.2). By clicking this icon
the
Timer
window for parameter settings opens.