Metrohm IC Net 2.0 - Manual (Page 130)

7 Methods
IC Net 2.0 122
Number
Row number (read-only).
Peak
Number of the peak in the chromatogram
that corresponds to the given component.
If this field contains a
0
, the peak number
must be entered manually.
Time Expected retention time of the compo-
nent in the calibration run. After a new entry
of the peak number the corresponding re-
tention time is entered automatically as
soon as this field is clicked on with the
mouse.
Wind.% Identification window of the component.
This value is the maximum allowed differ-
ence of the actual retention time of the
component and its expected retention time,
measured as % of expected retention time.
The component will be identified within its
identification window only.
Ref. Reference component. The entry Yes de-
fines components as reference compo-
nents; these ensure improved peak identifi-
cation of the other Ordinary components
(details see on-line help).
Name
Component’s name (cannot include
spaces).
Group
Number of the group to which the compo-
nents are allocated. If group numbers
≥ 1
are entered here then a group report can
be outputted for each group; this also
contains the intermediate totals for this
group. This group report is produced after
the main report table.
Index Retention index for components with
known index. In the case of an unknown in-
dex this value should be equal to 0 . For in-
dex calculation the user must define index
values for at least two peaks, and all other
values will be calculated by the software
using linear or logarithmic approximation
(details see on-line help).
RF Response factor. This value corresponds
to the slope of the calibration curve
(coefficient k
1
of the calibration formula).