Installation and configuration – ADS Environmental Services FlowAlert QR 775011 A2 User Manual

Page 10

Advertising
background image

Introduction 1-5

Installation and Configuration

Following is the general procedure for installing and configuring a
FlowAlert monitoring system. Refer to Chapters 3 through 6 for
detailed instructions and information.

Investigate the Site Characteristics

Install the Pressure Depth Sensor

• Assemble the Ring (when applicable)
• Mount the Sensor to the Ring or Special Bands (when

applicable)

• Secure the Sensor Cable to the Ring or Special Bands

(when applicable)

• Install the Pressure Depth Sensor
• Secure the Sensor Cable in the Pipe and the Manhole

Install the Float Switch(es) in the Manhole

Connect the Sensor and Float Switch to the Monitor

Attach the Dryer Tube to the Monitor

Establish Wireless, Telephone, or On-Site

Communication with Monitor

Configure the Monitor (using Profile

®

Software)

• Create the Monitor Location
• Create the Installation Table (when necessary)
• Select and Edit the Devices

Set the Communication Parameters (Profile)

Activate the Monitor (Profile)

Run Diagnostics and Perform Confirmations (Profile)

Install the Monitor in the Manhole

Advertising