ADS Environmental Services FlowAlert QR 775011 A2 - Manual (Page 117)

Configuration and Activation 5-13
Profile includes the device in the LIF. Deselect the
checkboxes corresponding to the devices you want to remove
from association with the selected monitoring point from the
Available Devices section.
Note: Profile selects the Float device for the FlowAlert
monitor by default.
The selected devices display in the Monitoring Point Devices
section.
5. Repeat steps 4 through 5 to assign devices to Monitoring Point
2, when applicable.
6. As necessary, edit the parameters specific to each device in the
following way:
 Access the device parameters by selecting (highlighting)
the device you want to edit in the Monitoring Point
Devices section and then clicking on the Edit button.
 Refer to the following sections for details concerning the
specific device parameters.
7. Once you have edited the devices as necessary, click on the
OK button to save the devices to the LIF.
Editing the Float Device(s)
Edit the parameters for each float switch device in the following
way, and then click on the OK button when complete:
Note: If the FlowAlert is supporting two float switches,
configure them both on the Edit Float Switch Parameters
dialog. Although the floats are configured on the same
dialog, each one represents an individual device.