ADS Environmental Services FlowAlert QR 775011 A2 - Manual (Page 85)

Communication 4-17
Installing the SIM Card
FlowAlert monitors require a standard SIM card for wireless
communication. This card must be installed in the monitor before
communication can occur. The monitor uses SIM cards provisioned
by AT&T (ADS p/n 507181) for public static IP address operation.
Please contact ADS for specific information on procuring SIM
cards for use in the specific geographic area.
Install the SIM card in the monitor in the following way:
1. Record the number from the SIM card (i.e., the IP address) on
the site report. This address is required for reconciling billing
and setting up the LIF in the Profile software. This IP address
is printed directly on the SIM card or on a label affixed to the
card.
Sample SIM card
2. Loosen the bolts and remove the monitor lid (top) from the
aluminum canister.
Note: Removing the monitor lid during SIM card
installation increases the risk of damaging or introducing
debris or moisture to the circuit board. Make every effort
to prevent water, dirt, and debris from contacting the
monitor’s circuit board during SIM card installation.
3. Lay the monitor top upside down with the plastic dust cover
protecting the printed circuit board facing upward.