ADS Environmental Services FlowAlert QR 775011 A2 User Manual
Page 67
3-44
ADS FlowAlert Manual
corresponding connector(s) on the pigtail. Tighten the
connector in a clockwise direction until it clicks, and verify that
it is seated correctly.
7. For locations exhibiting the presence of hydrogen sulfide
and/or high moisture, provide added protection by wrapping
the connection with rubber stretch tape.
8. Seal any unused connectors with a cap. If necessary, obtain
additional caps from the regional ADS representative.
Note: An air valve is present on the top of the monitor.
This valve exists only for testing purposes during the
manufacturing process. Please do not attempt to fill the
monitor with air or pressurize the monitor! In addition,
make sure the cap is tight on the air valve to prevent the
valve components from corroding.