ADS Environmental Services FlowAlert QR 775011 A2 - Manual (Page 55)

3-32 ADS FlowAlert Manual
Quantity Description ADS Part Number
4 6-32 × 1-inch machine screw I35-0004
4 6-32 × 5/16 inch nut I15-0003
15 plastic push mounts I01-0006
1 sensor mounting strap 700-100238-00
2. Gather the following tools and supplies:
 Battery-powered hammer drill with assorted bits –
including the following, at a minimum:
 3/8-inch x 4-inch (minimum length) masonry bit
 ¼-inch masonry bit (F35-0018)
 5/16-inch carbide-tipped drill bit (include smaller bits)
 4-pound hammer
 Rubber mallet
 Wrenches
 Screwdrivers (flathead and Phillips head of assorted sizes)
 3/8 – 16 thread tap
 Diagonal wire cutters
 Folding carpenter’s rule with a brass slide
 Rubber stretch tape
3. Determine the appropriate location on the manhole or wet well
wall to mount the sensor.
4. Hold the pressure mounting strap (ADS p/n 700-100238-00)
vertically against the wall at the selected location, and mark the
wall through the top hole of the strap.