ADS Environmental Services FlowAlert QR 775011 A2 - Manual (Page 31)

3-8 ADS FlowAlert Manual
Gathering Tools and Equipment
Gather the following tools for the installation:
 Battery-powered hammer drill with assorted bits – including
the following, at a minimum:
 ¼-inch x 6-inch masonry bit
 3/8-inch x 4-inch (minimum length) masonry bit
 5/16-inch carbide-tipped bit (include smaller bits)
 4-pound hammer
 Rubber mallet
 24-inch carpenter’s level
 7/16-inch nut driver
 Wrenches
 Screwdrivers (flathead and Phillips head of assorted sizes)
 3/8 – 16 thread tap
 Diagonal wire cutters
 Folding carpenter’s rule with a brass slide
 Rubber stretch tape
Assembling the Ring
The pressure depth sensor mounts to a stainless steel ring that is
installed in the pipe. Several different ring sizes exist, and each ring
is adjustable within about 3 inches to fit pipes of different
diameters. Assemble the ring as follows:
Note: These instructions generally apply to overlapping
rings. However, the 8-, 10-, and 12-inch rings do not have
an overlapping section. Therefore, these non-overlapping
rings will require small modifications to the assembly
process. To assemble a non-overlapping ring, proceed
directly to step 4.