ADS Environmental Services FlowAlert QR 775011 A2 - Manual (Page 44)

Pressure Depth Sensor and Float Switch Installation 3-21
Performing a special installation involves the following process:
 Gathering the parts and supplies
 Gathering the tools and equipment
 Mounting the pressure depth sensor
 Securing the cables to the band
Before beginning the installation, conduct a thorough investigation
of hydraulic and other site conditions. The hydraulics of a site
directly affect the monitor's ability to accurately measure flow
depth. In addition, measure the horizontal and vertical pipe
dimensions carefully.
Caution: Handle the pressure depth sensor and cable
with extreme care. The sensor and cable contain delicate
mechanisms and electronics. Keep sharp objects away
from sensor cable, and avoid stepping or placing heavy
objects on the cable during installation.
Gathering Parts and Supplies
Be sure to obtain the following supplies before performing a special
installation to prevent any costly delays. When ordering, specify
the FlowAlert monitor special installation hardware.
Quantity Description ADS Part Number
1 FlowAlert monitor 6000-FAW or -FAL
1 monitor mounting bracket I40-0003
1 pressure depth sensor with two 4-
40 x 5/16-inch stainless steel
screws
3704-0010-40 (5 psi)
3704-0015-40 (15 psi)
3704-0016-40 (30 psi)
1 replacement dryer tube 3704-0032
1 direct connection cable 5000-0601
15 11-inch cable tie I05-0003
25 4-inch cable tie I05-0001
15 8-inch cable tie I05-0002