ADS Environmental Services FlowAlert QR 775011 A2 - Manual (Page 66)

Pressure Depth Sensor and Float Switch Installation 3-43
S
E
N
M
O
A
T
X
S
.
E
1
T
2 P S I
LY
A
W W W.ADSENV.COM
S T A O L F
P R E S S U R E
M M O C T
X
C
T
E R
P
I
O
D
WE R
S U T A T S
Product Complies With: FCC Part 15, Part 68
US: 6KDMD06AHS1
Contains GSM/GPRS Transceiver
N T ENNA
FCC ID: M2IGSM0108 R
Cable connector ports
2. Visually inspect the connectors on the cable(s) and adapter
(when applicable) and the FLOATS/PRESSURE connector
port on the monitor for debris or moisture. Clean off any
debris, and dry any surface moisture. Compressed air is useful
for removing moisture from the inside of the connectors or
ports (pin and socket surfaces).
3. Verify that the interfacial seal is present inside each connector
with pins. The bright orange, rubber seal should sit at the
bottom of the connector with the pins protruding through the
seal.
Note: If the user is connecting the floats pigtail (ADS p/n
6000-0021) to customer-supplied contacts, prepare this
connection before connecting the cable to the monitor.
4. Connect the float switch(es) cable, pigtail, or combination
cable to the FLOATS/PRESSURE port on the monitor.
Tighten the connector in a clockwise direction until it clicks,
and verify that it is seated correctly.
5. (applies only when using pressure depth sensor) Connect the
pressure depth sensor cable to the mating connector on the
pigtail. Tighten the connector in a clockwise direction until it
clicks, and verify that it is seated correctly.
6. (applies only when using customer-supplied floats or relays)
Connect the customer-supplied hardware cable to the