ADS Environmental Services FlowAlert QR 775011 A2 - Manual (Page 118)

5-14 ADS FlowAlert Manual
Edit Float Switch Parameters dialog
 Enable Select this checkbox in the Float [1 and/or 2] section
to activate the options for the float you want to edit.
 Alarm Select the kind of alarm you want to initiate when the
flow reaches the corresponding depth level.
Note: You may designate only one alarm for each device
when configuring the devices for a FlowAlert monitor.
However, the alarms can be distributed among the float
switches and the pressure depth sensor as applicable and
appropriate.
 Debounce Use the arrows to designate the minimum amount
of time, following a change in state, the float must remain in a
new state to activate an alarm or indicate a return to normal.
 Trip Point Enter the elevation at which the float changes
states.