Kontron AT8402 CLI - Manual (Page 101)

AT8402 Switching Commands
Page 2 - 69 AT8402 CLI Reference Manual
2.17 LLDP (802.1AB) Commands
This section describes the command you use to configure Link Layer Discovery
Protocol (LLDP), which is defined in the IEEE 802.1AB specification. LLDP allows
stations on an 802 LAN to advertise major capabilities and physical descriptions. The
advertisements allow a network management system (NMS) to access and display this
information.
2.17.1 lldp transmit
Use this command to enable the LLDP advertise capability.
Default disabled
Format
lldp transmit
Mode Interface Config
2.17.1.1 no lldp transmit
Use this command to return the local data transmission capability to the default.
Format
no lldp transmit
Mode Interface Config
2.17.2 lldp receive
Use this command to enable the LLDP receive capability.
Default disabled
Format lldp receive
Mode Interface Configuration
2.17.2.1 no lldp receive
Use this command to return the reception of LLDPDUs to the default value.
Format
lldp receive
Mode Interface Configuration
2.17.3 lldp timers
Use this command to set the timing parameters for local data transmission on ports
enabled for LLDP. The
<interval-seconds>
determines the number of seconds to
wait between transmitting local data LLDPDUs. The range is 1-32768 seconds. The
<hold-value>
is the multiplier on the transmit interval that sets the TTL in local data
LLDPDUs. The multiplier range is 2-10. The
<reinit-seconds>
is the delay before
re-initialization, and the range is 1-0 seconds.
Default interval—30 seconds
hold—4
reinit—2 seconds
Format lldp timers [interval <interval-seconds>] [hold <hold-
value>] [reinit <reinit-seconds>
]